The following instructions will help you set up an encrypted mesh network on Raspberry Pi’s. It takes about 15 minutes to set up a node with the Pi 3. Obviously, to have a mesh you will need more than one node.
The software also supports Debian running on x86 and x64 boards, and many board that run Armbian (such as many models of Orange Pi hardware family). The same installation steps can be followed, except you would flash the SD card with Armbian instead of Raspbian or have Debian installed onto the computer. See Hardware Table for the full list of supported hardware and check for board specific installation details in our Frequently Asked Questions.
https://tomesh.net/build-a-node/
No comments:
Post a Comment
.
AREDN -
Amateur Radio Emergency Data Network
A focus on MESH, all hams are welcome!
https://groups.io/g/AREDN
.